Step 4:
Installation of the computer (44) at computer holder (5).
1. Put the plug of pulse connection cable 3 (45) and connection cable (30)
into the cable sockets from monitor (44).
2. Attach the monitor (44) to computer holder (5) and tighten with screws
M4x10(24) and washers 4//8 (52). (Attention: Ensure that the cable loom
are not crunched or pinched during installation.)
Step 5:
Attach the seat holder (2) and seat frame (4).
1. Put the seat handle (8) onto the axle (19) so that the holes are aligned
and screw it tightly by using screws M6x10 (22).
(To adjust the seat position, unlock the seat by pull the seat handle (8)
upwards. After reach new seat position push seat handle (8) downwards
to secure.)
2. Push the seat frame (4) through the holder of seat holder (2) and take
care of the right direction.
3. Place the seat frame (4) with seat holder (2) onto the holder of main
frame (1) and screw it tightly with screws M8x16 (14), spring washers
(13) and washers 8//16 (15).
22