Electronic Speed Controller (Esc) - Arrma BUGGY TYPHON BLX3S Mode D'emploi

Motor wires x 3
Power Switch & Set button
Input Voltage
Throttle
Setup
1. TX in neutral - press set
button (1 Green lash)
w.modellmarkt24.ch; w.modellmarkt24.ch;

Electronic Speed Controller (ESC)

Only use fully charged LiPo batteries (4.2V per cell) to prevent
battery/ESC damage.
EC5 Battery Plug
2S-3S LiPo (7.4-11.1v)
35C 5000mAh Minimum
6-8 Cell NiMh (7.2v-9.6v)
Req.
Connect batteries, turn on TX and press/hold the set button 'A'. Turn the switch on
'B' and release the set button when the RED light lashes on the ESC.
2. TX full throttle - press set
4. Switch of ESC to complete setup
ESC Speciications
button (2 Green lashes)
11
www.modellmarkt24. www.modellmarkt24.
HEAT-SINK MAY BE
HOT AFTER USE
Receiver Plug (CH2)
BEC Output 6.0v/6A Max
3. TX full brake - press set
button (3 Green lashes)
A
B