Factory Reset - Arrma BUGGY TYPHON BLX3S Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Failsafe Setup
Place vehicle of the
ground

Factory Reset

To reset end point
adjustment:
Contains FCC ID: IYFTTX300.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
FCC Rf Radiated Exposure Statement: The equipment complies with FCC Rf radiation exposure
limits set forth for an uncontrolled environment. This equipment should be installed and operated
with a minimum distance of 20 centimeters between the radiator and your body.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAU-
THORISED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER'S AUTHORITY
TO OPERATE THE EQUIPMENT.
Industry Canada Notice This device complies with Industry Canada license-exempt RSS standard(s). 1. Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired
operation of the device. 2. Changes or modiications not expressly approved by the party responsible for compliance could void the user's authority to
operate the equipment.
This equipment complies with IC radiation exposure limits set forth for an controlled environment. In order to avoid the possibility of exceeding the IC
radio frequency exposure limits, Human proximity to the antenna shall not be less than 20cm during normal operation.
Caution: Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to the instructions.
1. Use only four (4) AA alkaline batteries in your TTX300 transmitter.
2. Do not dispose of the battery in a ire as it may explode. Check with local codes for possible special disposal instructions.
3. Do not open or mutilate the battery. Released electrolyte is corrosive and may cause damage to the eyes and skin. It may be toxic if
swallowed.
4. Exercise care in handling batteries in order not to short the battery with conducting materials such as rings, bracelets and keys. The
battery or conduction material may over-heat and cause burns.
w.modellmarkt24.ch;
w.modellmarkt24.ch;
Switch on
throttle to desired position
transmitter and
car
Turn steer-wheel
fully left
INSTRUCTIONS FOR DISPOSAL OF WASTE EQUIPMENT BY PRIVATE USERS IN THE EUROPEAN UNION: This symbol on
the product or its packaging indicates this product must not be disposed of with other household waste. Instead, it is the user's
responsibility to dispose of their waste equipment by handing it over to a designated collection point for the recycling of waster
electrical and electronic equipment. The separate collection and recycling of your waste equipment at time of disposal will help to
conserve natural resources and ensure that it is recycled in a manner that protects human health and the environment. For more
information about where you can drop of your waste equipment for recycling, please contact your local city oice, your household
waste disposal service or location where you purchased the product.
Set steering and/or
Press and hold
for failsafe
Apply full brake (push)
Product Name: 2.4Ghz Transmitter
15
www.modellmarkt24.
www.modellmarkt24.
Receiver
bind button
LED will
blink 3
times
Power LED will lash
Power on Transmitter
Model Number: TTX300.
Release bind
button
ive times
RED
Directive
2014/53/EU
arrma-rc.com/ce

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Tactic ttx300198114x4 blx

Table des Matières