Factory Defaults; End Point Adjustment - Arrma BUGGY TYPHON BLX3S Mode D'emploi

CH1-
NOR
ST
CH2-
NOR
TH
Binding
Remove receiver
box lid

End Point Adjustment

To enter programming
mode:
Place vehicle of the
ground and switch
on
© 2018 ARRMA RC. A trade name of Horizon Hobby Ltd
w.modellmarkt24.ch; w.modellmarkt24.ch;

Factory Defaults

Steering CH1/Throttle CH2 channels see table. Steering and Throttle trim set to middle/zero
adjustment. Steering Dual Rate at 100% fully clockwise.
REV
REV
Press and hold
Switch on Car
bind button
Turn steer-wheel fully
right
Steering End Points
Turn steer-wheel left or
right
Receiver LED will
blink
Apply full throttle
Power on Transmitter
(pull)
Grip buttons move end
point
Always Turn of car irst and then transmitter to save settings
14
www.modellmarkt24. www.modellmarkt24.
LED stops blinking
Switch on
transmitter
Power LED will lash
ive times
Throttle End Points
The grip buttons
Apply throttle or
brake adjust the end points