Electronic Speed Controller (Esc) - Arrma SPEKTRUM STX2 Mode D'emploi

Electronic Speed Controller (ESC)

If using LiPo batteries you must set the correct battery mode on the ESC
(electronic speed controller) to prevent battery damage.
Motor Connectors
Battery Plug
Throttle Setup
Do not move the throttle when switching the model on as the ESC will
automatically set the throttle neutral. A long beep will sound to confirm
setup.
ESC Specifications
Input Voltage
ESC Status LED
Low Voltage Cut Off
Battery Mode
Cut-off Voltage
Factory Defaults
Heat-sink
Setting 'Jumpers'
6-7 NiMh (7.2-8.4v) / 2S Lipo (7.4v)
LED off: Neutral throttle
LED blinking slowly: Partial Forward/Reverse/Brake
LED solidly on: Full Forward/Reverse/Brake
HEAT-SINK MAY BE HOT AFTER USE
Power Switch
BEC Output
NiMh
4.5v
Battery Mode: NiMh
Reverse: On
16
Receiver Plug
(CH2)
6.0v/2A Max
LiPo
6.4v
WWW.ARRMA-RC.COM