Use Of Product; Hob Controls - Burg BCF30-TZK Notice D'utilisation

4. USE OF PRODUCT

4.1 Hob Controls

The appliance is operated by touching
buttons, confirmed by displays and
audible sounds.
1 2
3
7 8
1- Heater display
2- Activate/Deactivate heater
3- Dual zone selection
4- Heat setting/timer increase
5- Timer display
6- Key lock
7- Dual zone indicator
8- Decimal point
9- Heat setting/timer decrease
10- Timer function cooking zone indicators
11- Activate/Deactivate timer
12- On/Off
13- Key lock indicator
Mode Descriptions
Stand-By-
S-Mode
Mode
Operating-
B-Mode
Mode
VR-
Lock Mode
Mode
Switching the Appliance On and Off
If the appliance is in Stand-By mode, it
is put in Operating mode by pressing the
On/Off button for at least 1 second. A
buzzer will sound to indicate the successful
operation.
A "0" will appear on all heater displays and
all decimal points corresponding to the
heaters will flash (1 second on, 1 second
off).
If there is no operation within 10 seconds,
the display on all heaters will switch off.
If the displays do switch off, the heater will
4 5 6
9 10 11 12
The mains is applied to the
hob control and all heater
displays are off or a residual
heat display is active.
At least one heater display
shows a heat setting
between ´0` and ´9`.
The hob control is locked.
be sent into Stand-By mode.
If is pressed for more than 2 seconds
(in Operating mode), the appliance will
switch off and will enter S-Mode again. The
appliance can be switched off by pressing
at any time; even if other buttons are
pressed simultaneously.
If there is any residual heat from a heater,
this will be indicated in the corresponding
Heater Display with a "H".
Selecting a Heater
If a single heater is chosen with the
corresponding Activate/Deactivate Heater
Button , the decimal point of the Heater
Display will flash. For the selected heater,
13
the heat level can be set between 1 and 9
by pressing the Heat Setting Buttons
.
The buttons must be pressed within 3
seconds of selecting a heater, otherwise the
heater selection will be erased and the heat
setting decimal point will disappear. If there
is no further operation within 10 seconds,
the heater will revert back to S-Mode.
The heat setting can always be changed by
pressing
are between 1 and 9.
Each button operation or each display
change is accompanied by a buzzer sound.
Switching On the Dual Zone
The Dual Zone can be activated by
pressing , after a heater and the desired
heat level (between 1 and 9) is selected.
This will be confirmed by a buzzer sound.
At the same time, the corresponding Dual
Zone Indicator will illuminate. To deactivate
the Dual Zone, press
Set Cooking Level with and without Heat
Boost
All heaters are equipped with the heat
boost function.
If the heat boost is required, set the heat
from the current level to level 9 by pressing
the button only. Once level 9 has been
reached, press
boost. The display will flash "A" alternating
with the heat setting value "9" to show the
heat boost is active.
If the heat boost is active, the heater will
operate with maximum power for a period of
time dependent on the heat setting selected
before the heat boost was activated.
Once the heat boost time has ended, only
the heat setting will be indicated on the
heater display.
EN - 13
or . The available settings
a second time.
to activate the heat
or