Mains Connection - Jet JRD-387A Mode D'emploi

A.....Pulley cover
B.....Motor
C....V-belt tension lever
D....Rising handle
E....Column lock handle
F....Machine basement
G....Working table
H.....Chuck guard
I......Chuck
J.....Depth stop
K....ON / OFF Switch
L....Downfeed handles
M....Horizontal column adjustment
N....Head 90° indexing
O... .Horizontal column lock
P....Emergency switch
The machine is designed to operate in closed rooms and
must be placed stable on a firm and levelled table surface.
The machine can be bolted down if required.
For packing reasons the machine is not completely
assembled.
If you notice transport damage while unpacking, notify your
supplier immediately. Do not operate the machine!
Dispose of the packing in an environmentally friendly
manner.
Clean all rust protected surfaces with a mild solvent e.g.
petroleum.
(Note: lacquer thinner or similar can destroy the paint).
Slide the rising handle (D, Fig 2) onto the table bracket shaft.
L
H
Turn the handle until the clamping screw is opposite the flat
section on the shaft and tighten the clamping screw (T).
Install three down feed handles (L) into the down feed hub.
Install the chuck guard (H).
JRD-387A
Lubricate gently with grease.
-the drive splines (grooves) in the spindle
-the teeth of the quill
-the column-rack
Mains connection and any extension cords used must comply
with applicable regulations.
The mains voltage must comply with the information on the
machine licence plate.
The mains connection must have a
10 A surge-proof fuse.
Only use power cords marked H07RN-F
Connections and repairs to the electrical equipment may only
be carried out by qualified electricians.
You can start the machine with the green on button. The red
button on the main switch stops the machine.
If the direction of rotation is not correct, the phase converter
inside the CCE Euro plug must be pushed in and turned
180°.
Before further using the drill press, it is advisable to break in
the V-belt.
Tighten the belt and keep the machine running at 1450 rpm
for approximately 30 minutes.
Always adjust the table and the depth stop to prevent drilling
into the table. Use a back-up piece of scrap wood to cover
the table. This protects both the table and the drill bit.
Secure workpiece to the table with clamps or a vice to
prevent rotating with the drill bit.
T-slot size is 14 mm.
Feed the bit into the material with only enough force to allow
the drill bit to work.
Feeding too slowly may cause burning of the workpiece.
Feeding too quickly may cause the motor to stop and/or the
T
drill bit to break.
D
R
Wood:
Plastic:
Aluminium:
Brass:
Cast iron:
Mild steel:
2000 RPM
1500 RPM
1500 RPM
1500 RPM
1000 RPM
800 RPM