Weidmüller VT LCL Mode D'emploi page 12

4. Intended Use
The tester may be used only under
the conditions and for the purposes
for which it was designed. Therefore,
observe in particular the safety instruc-
tions, the technical data including envi-
ronmental conditions.
5. Tester Information
4
1
2
1.
2.
3.
4.
5.
6.
7.
8.
6. Preparation of testing
• Switch on the tester by pressing long
the ON / OFF button.
• By default, the 50...1000 V test-
ing range is activated. Press the
ON / OFF button short time for switch-
ing to the 12...50 V range. The test-
er shows in the 12...50 V range also
voltages between 50...1000 V. If a
voltage source above 50 V is present
close to a 12 V voltage source, the
tester will detect the stronger source.
(VT LCL)
• A red LED flashes slowly to show
readiness
• The tester is switched off by pressing
ON / OFF long time
• The tester has an auto power off after
3 minutes
12
The tester may be opened by an
authorized service technician
only.
6 7
3
Test tip for voltage test
(VT LCL)
Torch Light
Display area
Test area for magnetic
field testing (VT M)
Grip area
On/Off, Selection of sensitivity
voltage test (VT LCL)
Torch light button
Battery door
5
8