HBM Z4A Manuel D'emploi page 42

42
If the transducer is connected according to the following connection diagram
then when the transducer has compressive loading the output voltage at the
measuring amplifier is positive.
Six-wire connection
Fig. 6.2: Z4A pin assignment
HBM
WH (white) Measurement signal (+) U
BK (black) Excitation voltage (−) U
RD (red) Measurement signal (−) U
BU (blue) Excitation voltage (+) U
GN (green) Sensor circuit (+)
GY (grey) Sensor circuit (−)
shield Cable shielding, connected to housing
Z4A
A
B
A
B
A0697-7.0 de/en/fr