Technical Information; Installation Considerations - Hansgrohe Raindance Select Showerpipe 240 27115 1 Série Instructions De Montage / Mode D'emploi / Garantie

English

Technical Information

Recommended water pressure
Max. water pressure
Recommended hot water temp. 120° - 140° F*
Max. hot water temp
Flow rate - showerhead
Flow rate - handshower
* Please know and follow all applicable local plumb-
ing codes when setting the temperature on the water
heater.

Installation Considerations

This showerpipe requires showerpipe
rough 16181181(not included).
• For best results, Hansgrohe recommends that
this unit be installed by a licensed, professional
plumber.
• Please read over these instructions thoroughly
before beginning installation. Make sure that
you have all tools and supplies needed to
complete the installation.
• The installation dimensions shown in this
installation instruction are ideal for people of
approximately 6' in height. The dimensions can
be changed if required. In this case, the minimum
ceiling height of 88⅛" from the standing surface,
and all other measurements, must be changed.
• Make sure that the wall is strong enough to
support the showerpipe. Hansgrohe strongly
suggests installation of a header at the top
mounting point.
This unit meets or exceeds the
following:
• ASME A112.18.1 / CSA B125.1
• Listed by IAPMO for use in the
US and Canada
2
15 - 75 PSI
145 PSI
176°F*
2.5 GPM max.
2.5 GPM max.
• The area where the top mounting piece is to be
• The enclosed screws and anchors are suitable for
• This showerpipe is for use with shower heads
• To prevent scald injury, the maximum output
• Keep this booklet and the receipt (or other proof
installed must be flat and free of protruding grout
joints, etc.
a solid surface wall. For other wall constructions,
select mounting hardware and reinforcement
suitable for that specific construction.
rated at 2.5 GPM (9.5 l/min) or higher.
temperature of the shower valve must be no
higher than 120°F. In Massachusetts, the
maximum output temperature can be no higher
than 112° F.
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.