Maintenance; General; Daily Cleaning; Cleaning The Air Inlet Filter - Hatco Rapide Cuisine IRNG Série Manuel D'installation Et D'utilisation

English

General

Hatco Induction Ranges are designed for maximum
durability and performance with minimum maintenance.
WARNING
ELECTRIC SHOCK HAZARD:
• Turn OFF power, unplug power cord, and allow unit to
cool before performing any cleaning, adjustments, or

maintenance.

• DO NOT submerge or saturate with water. Do not allow
liquids to spill into unit. Unit is not waterproof. Do not
operate if unit has been submerged or saturated with water.
• Do not steam clean or use excessive water on the unit.
• This unit is not "jet-proof" construction. Do not use
jet-clean spray to clean this unit.
• Do not clean unit when it is energized or hot.
• Discontinue use if power cord is frayed or worn.
• Do not attempt to repair or replace a damaged power
cord. Cord must be replaced by an Authorized Hatco
Service Agent or a person with similar qualifications.
• This unit must be serviced by qualified personnel only.
Service by unqualified personnel may lead to electric
shock or burn.
• Use only Genuine Hatco Replacement Parts when
service is required. Failure to use Genuine Hatco
Replacement Parts will void all warranties and may
subject operators of the equipment to hazardous
electrical voltage, resulting in electrical shock or burn.
Genuine Hatco Replacement Parts are specified to
operate safely in the environments in which they are
used. Some after-market or generic replacement parts
do not have the characteristics that will allow them to
operate safely in Hatco equipment.
This unit has no "user-serviceable" parts. If service
is required on this unit, contact an Authorized Hatco
Service Agent or contact the Hatco Service Department at
800-558-0607 or 414-671-6350.
Use only wipes, pads, and cleaners designed specifically
for cleaning ceramic glass surfaces.
Wipe up all spills and splashes immediately. Make sure
unit is dry before using. Do not allow liquid to run into air
inlet filter on bottom of unit.
Form No. IRNGHM-0117
CAUTION

Daily Cleaning

To maintain performance and preserve the finish of the
Induction Range, clean the unit daily. Make sure to use only
wipes, pads, and cleaners designed specifically for cleaning
ceramic glass surfaces.
1. Turn off and unplug the unit. Allow the unit to cool.
2. Remove and wash all food pans.
3. Clean the glass surface using an appropriate cleaning
wipe, damp paper towel, or damp cloth.
• For tough stains and metal marks, use a drop of ceramic
glass cleaner and paper towel.
• For water and scale marks, use a few drops of white
vinegar and paper towel.
Use non-abrasive cleaners and cloths only. Abrasive
cleaners and cloths could scratch finish of unit, marring its
appearance and making it susceptible to soil accumulation.
4. Clean the metal surfaces using a clean, soft cloth and mild
detergent.
5. Wipe dry all metal surfaces using a dry, clean, soft cloth.

Cleaning the Air Inlet Filter

The air inlet filter on the bottom of the unit should be removed
and cleaned monthly or sooner during heavy use. Use the
following procedure to clean the filter.
1. Turn off and unplug the unit. Allow the unit to cool.
2. Remove the air inlet filter by sliding the filter out of the filter
frame underneath the front of the unit.
3. Clean the air inlet filter with mild soap and water.
4. Allow the air inlet filter to dry completely.
5. Slide the air inlet filter into the filter frame underneath the
front of the unit.
Air Inlet Filter
Filter Frame
Cleaning the Air Inlet Filter
9
MAINTENANCE
NOTICE