LOTRONIC AFX light IBOX-H5 Manuel D'utilisation page 8

On
IR
Off
On
Menu lock
Off
On
Factory Reset
Off
DMX Addressing
Each fixture must be given a DMX address so that the correct fixture responds to the correct control
signals. This DMX address is the channel number from which the fixture starts to "listen" to the
digital control information being sent out from the controller.
This fixture has 3 DMX channel modes, 6, 8 and 12 DMX channels. To set up fixture DMX address,
first select DMX channel mode. The highest DMX address for this fixture is 512. To set up fixture
DMX starting address, follow the steps below:
• Switch on the fixture, press Menu till "Channel" appears;
• Press "Up" or "Down" button to select 6CH or 8CH or 12CH;
• Press "Enter" to confirm your selection.
• Press "Menu" repeatedly to come back to "Address 001";
• Set up DMX address by scrolling "Up"/" Down" button.
• Press "Enter" to save your setting.
Wireless DMX Setup
This fixture can be controlled via a wireless DMX system. Users need to pair the fixture to a wireless
DMX transmitter first. There is one wireless DMX indicator near the OLED display. This indicator
shows the status of the wireless DMX connection.
Indicator Status
Blue light on
Blue light slow
flashing
Blue light fast
flashing
Blue light off
Pairing to a New Transmitter
To operate the fixture with wireless DMX, you need to connect your fixtures to a wireless DMX
transmitter first.
After the fixture is switched on, and if there is no new transmitter, it will connect to the previous
transmitter automatically, no need to re-pair it.
If your fixture has already worked with another wireless DMX transmitter, and you want to pair
with a new wireless DMX transmitter, you need to erase the previous wireless DMX memory first
before pairing. To clear the wireless DMX memory, continue pressing "Menu" till you see "Wireless
DMX". Press Up/Down to select "Clear" and press "Enter" to clear the wireless DMX memory. Then
the blue light will turn off after about 5 seconds.
To pair the fixture and a new transmitter, after having cleared the fixture's wireless DMX memory
(make sure the wireless DMX indicator is Off), press the pairing button on the transmitter. The
fixture's indicator will start flashing fast and then stay on. This means that pairing has been suc-
cessful.
In optimal conditions, the master unit can operate up to 200m (at open sight) away from the slave
units. Please remove all obstacles between the fixtures. Once the fixture has been linked to a spe-
cific transmitter, it will remain linked to that unit until it is linked to another one by clearing the
initial wireless DMX signal.
EN 8
Description
Fixture receiving wireless DMX signal from transmitter.
Fixture already connected to transmitter, but no signal coming from trans-
mitter.
Fixture not connected to transmitter; it keeps the wireless DMX memory
from last pair.
Fixture not connected to transmitter, and no wireless DMX memory
IR setting
Menu Lock
Factory default setting
© Copyright LOTRONIC 2020