Changing The Oil; Troubleshooting Guide - Tyco Electronics 0-0523199-2 Manuel D'utilisation

6-744011-7 412-18745 Rev.B

8.4 Changing the oil

1. Drain all oil and refill with clean original oil every 12 months. If pump is used in dirty environments,
change the oil more often.
2. Remove vent/fill cap or plug from reservoir.
3. Tilt pump to drain out old oil.
4. Fill reservoir only to level mark shown on pump.
5. Replace the vent/fill cap or plug.
6. Dispose of used oil properly.
9

Troubleshooting guide

The following information is intended as an aid in determining if a problem exists. For repair service,
contact the authorized Tyco Electronics Service Centre in your area.
Table 2
Page 26 / 26 ECOC: EGC0 ; LOC: AI