Oceanic OCEAISH1750W0 Guide D'utilisation page 45

Setting of 7 pre-set 24-hour programs (P1~P7)
Under program mode setting interface, regardless of which day, when you choose program from
P1 to P7, press and hold OK-boost for 3 seconds to enter the setting interface of the mode. The
setting will be memorized (in case of power failure, it will also be memorized).
1. Select mode for the hour: press + to choose comfort mode , - to choose ECO mode
OK-boost to keep previous setting. After on, it will automatically go to setting for next hour.
2. At the last hour, press + / -, or OK-boost to finish the setting and go back to previous
setting interface.
For example, if you enter the P1 setting from below interface (day 1, P1), it will go back to
below interface (day 1, P1) after you finish P1 24-hour setting.
Notes:
1. If there is no battery, the unit keep in memory only the parameters, temperature and
operating mode. When power is restored, the clock should be adjusted again to operate
the program modes properly.
2. After you finish program mode setting, it will be saved but will not automatically start
working at program mode. You need to press OK-boost to choose program mode to
make the heater work at this mode.
3. Window detection mode
Press MENU to display the setting menu interface and choose the window detection function
by pressing + / -. Then press
Hour
+ / - to choose "ON" or "OFF". If "ON" is selected, the window
Page 44 of 48
, or