Applications; Prior To Operation - Metabo HPT EC 99S Manuel D'utilisation

English
SPECIFICATIONS
Model
Motor
Power Source
Running Horse Power
Current
Tank Capacity
Maximum Pressure
Free Air Delivery
Lubrication
Weight
ACCESSORY
WARNING
: Accessory other than these shown
below can lead to malfunction and
resulting injuries.
STANDARD ACCESSORY
Dipstick ....................................................1

APPLICATIONS

Air source of the pneumatic nailer and stapler.
WARNING
: Never use compressor for applications
other than compressor for pneumatic
nailer and stapler.

PRIOR TO OPERATION

1. Power source
Ensure that the power source to be utilized conforms to
the power source requirements specifi ed on the product
nameplate.
2. Power switch
Ensure that the knob of the pressure switch is in the "OFF"
position (Fig. 2). If the plug is connected to a receptacle
while the knob is in the "ON" position, the compressor will
start operating immediately and can cause serious injury.
OFF
Knob of the pressure switch
at 40 PSI (2.8 bar)
at 90 PSI (6.2 bar)
at 100 PSI (6.9 bar)
ON
Fig. 2
Single-Phase, Induction Motor
Single-Phase, 120 V AC 60 Hz
2 HP (1.45 KW)
4 gal. (15.1 ltr)
135 PSI (9.3 bar)
3.64 CFM (103 ltr/min)
3.10 CFM (88 ltr/min)
3.05 CFM (86 ltr/min)
52.9 lbs (24 kg)
3. Extension cord
When the work area is far away from the power source,
use an extension cord of suffi cient thickness and rated
capacity (refer page 7). The extension cord should be kept
as short as practicable.
WARNING
: Damaged cord must be replaced or
repaired.
4. Confi rm the power receptacle
If the power receptacle only loosely accepts the plug, the
receptacle must be repaired. Contact the nearest electric
store for repair service.
If such a faulty receptacle is used, may cause overheating,
resulting in a serious hazard.
5. To check the safety valve.
Before starting compressor, pull the ring on the safety
valve to make sure that the safety valve operates smoothly.
(Fig. 3) Do not use compressor if the safety valve is stuck
or does not operate smoothly. Have defective safety valve
replaced by a metabo HPT authorized service center.
WARNING
: Drain tank to release air pressure
before pull the ring on the safety
valve.
WARNING
: Risk of bursting.
If the safety valve does not work
properly,
occur, causing air tank rupture or an
explosion.
— 10 —
EC99S
15 A
Oil
Safety valve
Fig. 3
over-pressurization may