Cleaning And Storing - Pattfield Ergo Tools E-EAS 620 Mode D'emploi D'origine

Anleitung_E_EAS_620_SPK7__ 10.07.12 13:21 Seite 20
GB
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
L sound pressure level
pA
K uncertainty
pA
L sound power level
WA
K uncertainty
WA
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three directions)
determined in accordance with EN 60745.
Handle under load
Vibration emission value ah = 3.47 m/s
K uncertainty = 1.5 m/s 2
Warning!
The specified vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equipment
is used and may exceed the specified value in
exceptional circumstances.
The specified vibration value can be used to compare
the equipment with other electric power tools.
The specified vibration value can be used for initial
assessment of a harmful effect.
Reduce noise generation and vibration to a
minimum!
Use only equipment that is in perfect condition.
n
Maintain and clean the equipment regularly.
n
Adopt your way of working to the equipment.
n
Do not overload the equipment.
n
Have the equipment checked if necessary.
n
Switch off the equipment when not in use.
n
Wear gloves.
n
20
8. Maintenance
8.1 Replacing the saw chain and cutter rail
The cutter rail needs to be replaced if
the guide groove of the cutter rail is worn;
n
Proceed as described in the section "Assembly of the
83 dB(A)
cutter rail and the saw chain".
1 dB
8.2 Checking the automatic chain lubrication
103 dB(A)
You should check the operation of the automatic
3 dB
chain lubrication system on a regular basis in order to
guard against overheating and the associated
damage to the cutter rail and the saw chain. To do
this, point the tip of the cutter rail towards a smooth
surface (board, section of a cut tree) and allow the
chainsaw to run. If an increasing oil trace becomes
evident during this process then the automatic chain
lubrication system is working properly. If no clear oil
trace is evident then please refer to the corresponding
2
instructions in "Troubleshooting". If the information
contained there still fails to remedy the situation then
please contact our service department or another
similarly qualified workshop. Important! Do not
actually touch the surface with the tip of the cutter rail
when performing this test. Keep a safe distance
(approx. 20 cm).
8.3 Sharpening the saw chain
Effective working with the chainsaw is only possible if
the saw chain is in good condition and sharp. This
also reduces the risk of kickback. The saw chain can
be re-sharpened by any dealer. Do not attempt to
sharpen the saw chain yourself unless you have the
necessary special tools and experience.

9. Cleaning and storing

Regularly clean the clamping mechanism by
n
blowing it out with compressed air or cleaning it
with a brush. Do not use tools for cleaning.
Keep the handles free of grease so that you can
n
maintain a firm grip.
Clean the equipment as required with a damp
n
cloth and, if necessary, mild washing up liquid.
If the chainsaw is not to be used for an extended
n
period of time then you should remove the chain
oil from the tank. Briefly immerse the saw chain
and the cutter rail in an oil bath and then wrap
them in oil paper.