Amibot Spirit Origin Manuel D'utilisation page 83

Troubleshooting
"Please check and
06
clean turbo fan"
"Please clap front
07
bumper"
"Please clean
08
drop sensors"
"Please check the
09
radar sensor"
"Please put robot
10
back to ground"
"Please put robot
11 back to charging
dock to recharge"
"Please put out
12 the plug from
robot"
"Please turn on
13
power switch"
Problem with the fan or
motor.
The front bumper is
blocked.
The gap sensors are
dirty.
Problem with the laser
module
The robot is no longer in
contact with the ground.
The robot does not have
enough battery and it
cannot find its home
base.
The power cable is
plugged into the robot.
The robot is switched off.
It cannot be charged.
35
Switch the robot off
and let it cool down.
Turn it back on. If the
problem persists, please
contact the AMIBOT after-
sales service.
Check the front bumper
and gently tap it to loosen
it.
Clean the gap sensors
using a soft cloth.
Check the laser module
and remove any elements
that could prevent it from
functioning correctly.
Place the robot on a flat
surface and restart a clean-
ing cycle.
Manually place the robot
on its home base. Check
that the robot's power
sensors are in contact with
the home bases contacts.
Manually unplug the robot
to launch its cleaning cycle.
Switch the robot on by
pressing the ON/OFF
power button.
EN