ACME Zoopa Thunder 01 Manuel D'utilisation page 17

www.ACME-online.de
Rudder deflection
If you like to modify the rudder deflection, you can use the Dual rate switch that is located on
the upper Side. Please note: The lower the deflection is, the lower the boats latitude will be.
As a beginner, you can reduce the rate to slowly test the boat. You can higher the rate by
turning the switch to front (7:3).
Direction- and gas trims
To fine- adjust the L/R- movements, put the wheel into neutral position and push ST.TRIM.
Pushing it down modifies the left- movements, pushing it up adjusts the right- movements.
You can set the gas trims with TH.TRIM. Put the trigger into neutral position and use the
TH.TRIM switch accordingly.
Trouble shooting and Solution
Error
The boat does not react
on commands by the
controller
The boat makes strange
sounds
The controller has no
connection to the boat
The boat seems to be
sinking/ sucks water
The motor overheats
The motor does not run
You can contact us if you have any further problems! Our details are quoted on the
next page below "Service & Support".
Source
Batteries are not inserted
correctly.
Batteries are empty
The battery of the model is
empty
The propeller is damaged
Weak battery
Controller batteries are empty
Battery is defective
The model is out of range
The cockpit does not fit
correctly/is not secured
correctly
The battery is placed too far at
the front
The cooling system is blocked
The motor is wasted
ACME the game company
Solution
Check the battery case
Replace these
Recharge the battery
Check if the propeller is
fixed firmly
Recharge it
Replace these
Replace the boat battery
Remove it from the water
and restart it
Reclose the cockpit
Correct the battery position
inside the boat
Clean the cooling system
The motor needs to be
replaced