Connecting Cartridges To The Mains Water Supply And The Washer-Disinfector; Venting The Cartridges; Inserting A Cartridge - Miele professional PG 8595 Mode D'emploi

en - Connecting and installing cartridges
Venting the car‐
tridges
Inserting a car‐
tridge
40
Connecting cartridges to the mains water supply and
the washer-disinfector
Guide the hoses through the openings provided on the back of the

Aqua Purificator.
Ensure that the hoses are not kinked when doing this.

Connect the "H2O pur" (green) hose to the solenoid valve for AD

water or to the AD water inlet hose for the washer-disinfector.
Connect the "Inlet (Eingang)" (red) hose to the on-site cold water

mains supply stopcock.
Important
Water pressure (flow pressure) must be between 250 - 1000 kPa
pressure (2.5 - 10 bar).
The water temperature must not exceed 20 °C.
Open the valve by turning it to the left.

Open the cold water stopcock until water escapes from the valve.

until water escapes from the vent valve.
Then close the valve.

The demineralisation cartridge is now ready for use.
Place the connected cartridges into the back of the Aqua Purifica‐

tor.
The front area can be used to accommodate a spare cartridge.