KS Tools 160.0731 Notice D'utilisation page 11

3. Assembling the hydro-pneumatic jack
The hydro-pneumatic jack is delivered assembled and can easily be connected to an air compressor.
Diagram 1 shows how to connect the hydro-pneumatic jack correctly.
The compressed air extension hose used to connect the jack must be as short as possible.
The compressor should preferably be fitted with a filter and an oiler.
It is advisable to use a compressor with a minimum power of 3 HP.
1/4" quick coupler (Air supply)
1/4" male coupling
Air valve
Lever (#10-8)
Locking lever (#10-10)
Jack hose
Diagram 1
The extension support must be fixed as illustrated in diagram 2.
Use 2 clamps, a support bracket, 2 washers and 2 nuts.
When not in use, the 3 adapters are fixed on the support and secured by pins.
Jack handle
Clamp
Nut
Support for extension
Diagram 2