Before You Start - Atlantic TidalWave A-05 Manuel D'utilisation

• A-05/A-05L/A-21/A-31 pumps require a single phase 115 volt / 60 hz
power supply. A-32 pump requires a single phase 230 volt / 60 hz
power supply. Always verify that the supplied power meets the
requirements listed on the upper pump cover.
• DO NOT apply any paint over the stainless steel motor body. Reduced
cooling ability will result in overheating, overloading, undesirable
performance reductions, periodic auto shut-off and pump malfunction.
• Never place your hand or any object in or near the inlet opening while
this equipment is operating. If pump inlet is clogged, always turn off
the power supply, fuse box or circuit breaker and wait until the motor is
completely stopped before attempting to remove any clogged material.
• Please make sure that the power plug and the AC outlet receptacle is
protected and away from water or pump discharge hose to prevent
accidental electric shock or short circuit.
• Always operate the pump completely submerged in water.
• Avoid dry operation, which will not only lower performance but can
cause the pump to overheat/malfunction, leading to electrical leakage,
shock or premature failure.
• CAUTION:
THIS PUMP IS TO BE USED IN A CIRCUIT PROTECTED BY A GROUND CIRCUIT INTERRUPTER.
• CAUTION:
THIS PUMP HAS BEEN EVALUATED FOR USE IN WATER ONLY.

Before You Start

• Check the model name plate to make sure once again that the product
is of the correct voltage and frequency rating.
• The setting on the circuit breaker or other overload protector should
be made in accordance with the rated currency of the pump.
• Turn off the power supply or circuit breaker before inserting the power
supply plug to avoid electrical shock, shorting, or unexpected starting
of the pump, which could lead to injury.
• Never operate the pump while it is suspended in air. The recoil may
result in injury or other major accident.
3