Control Menu (Control); Protocol Dmx - Cameo OPUS H5 Manuel D'utilisation

CONTROL MENU (Control)

The control menu enables selection of the various operating modes and their settings in the relevant sub-menus.
DMX OPERATION VIA XLR INPUT
Starting from the main display, press the rotary-push encoder to enter the main menu. Select the Control menu by turning the encoder and
pressing the encoder. By turning the encoder you can now select the menu item Protocol, confirm by pressing the encoder and then select
DMX by turning the encoder and confirm by pressing the encoder.
Information on the sub-menu items in the DMX menu and the relevant setting options are to be found in the table below.

Protocol DMX

Select by turning the encoder, confirm by pressing, change value or status by turning, confirm by pressing. Back with BACK.
DMX Address Setting the DMX start address
DMX Mode Selecting the DMX mode
W transmitter Activate (On) or deactivate (Off) forwarding of the DMX signal via W-DMX
Establish (Linking) or release (Unlink) a connection to other W-DMX devices.
W-DMX standard Setting the W-DMX standard (G3 / G4s)
DMX OPERATION VIA W-DMX
Starting from the main display, press the rotary-push encoder to enter the main menu. Select the Control menu by turning and pressing the
encoder. By turning the encoder you can now select the menu item Protocol, confirm by pressing the encoder and then select WDMX by
turning the encoder and confirm by pressing the encoder.
001–512
29ch/36ch
On
Off
Linking
Unlink
G3
G4s
11