Installation/ Replacement - Bpt OH/Z.02 Mode D'emploi

2 - INSTALLATION/
REPLACEMENT
Install the unit in a suitable
position to detect the room
temperature correctly (fig. 2),
avoiding installation in niches,
behind doors or curtains or
near heat sources (fig. 3).
The module is to be installed
recessed in a 3-module box
(depth 50 mm) proceeding as
follows:
- Make the connections.
OK
24
GB
- Fasten the module to the
recessed box using the two
provided screws
observing the UP indication.
- Install the front plate.
NOTE. The unit is provided
with 3 adaptors for possible
use of some commercially
available models of front
plates.
Fig. 5 shows the use of the
module directly with the fol-
lowing front plates:
- BPT.
Fig. 2
- BTICINO (Art. L4803, Art.
N4803).
(fig. 4) - VIMAR Plana (Art. 14653).
Fig. 6 shows the use of the
module with the following
front plates:
- VIMAR (Idea series).
- AVE (System 45).
Fig. 7 shows the use of the use
of the module with GEWISS
front plate (Playbus).
For correct installation, it is
necessary to eliminate the two
joining rods of the hole cover
adaptor.
Fig. 3
7
6
5
4
3
2
1
Fig. 4