Perel EDB8 Mode D'emploi page 6

7.3 Receiver
1. Drill two holes with a diameter of 6 mm (distance 56 mm) at the
required height. Insert a nylon plug into each hole.
2. Insert a screw into each hole. Do not fully insert them but leave
about 5 mm free.
3. Hang the receiver onto the screws.
8. Operation
1. Press the auto-learning button on the back of the receiver.
2. Press the push button on the transmitter once. The receiver will
sound to indicate that the new operation code has been
registered.
3. Operate in the same way to memorize an extra transmitter.
4. Press the melody button to select one of the 36 melody. Press
the volume button to select the high, medium or low ring
volume.
Remark
If the receiver sounds for no reason during the learning procedure,
the signal may be subject to interference. Reset the code as
described above.
9. Cleaning and Maintenance
This device does not need any particular maintenance. Occasionally
wipe it with a damp cloth. Do not use harsh chemicals, cleaning
solvents or strong detergents.
10. Technical Specifications
operating distance........................... ± 100 m (in open field)
frequency....................................................... 433.92 MHz
ringing volume ............................... > 80 dB (within 0.5 m)
reception sensitivity .......................................... ≥ 80 dBm
transmitting power ............................................. ≤ 10 mW
transmitting current ............................................ < 15 mA
quiescent current (transmitter) ................................ < 5 µA
quiescent current (receiver) ................................ < 200 µA
digital code .................................................. auto-learning
modulation type ......................................................... ASK
dimensions
V. 01 – 21/12/2015
EDB8
6 ©Velleman nv