Operating - SKF TKSU 10 Mode D'emploi

2. Operating

5
8
• Open the battery compartment using a
Philips screwdriver. Correctly insert (+/-)
two AA alkaline or rechargeable batteries. The
remaining battery level is displayed here
1
• The device can be powered through its
USB port
6
or connected to a 5V USB power adapter.
It turns off automatically when the battery
7
power is insufficient to ensure proper operation,
or after 10 minutes of inactivity.
• Connect the supplied headset here
5
• The ON/OFF button is here
• Adjust amplification by using the up and down
arrows
(† 5)
guidance icons
- When the RMS measurement
2
displayed in green, the amplification is
correctly set.
4
- When red, the amplification is too high.
- When ''-.-'' is displayed, the amplification is
too low.
• The current amplification setting is displayed
here
(† 7)
3
• Adjust the audio volume by pressing the left
and right arrows
comfortable.
• The current volume setting is displayed
only when a headset is connected.
• To replace a damaged sensor
and replace it with a new one.
† 5 : increase
: correct
9
: decrease
† 6
too high
Red:
correct
Green:
''-.-'': too low
with an external battery pack
(† 2)
.
(† 4)
and following the amplification
.
(† 5)
(† 6)
.
until the sound level is
(† 5)
(† 9)
(† 1).
.
(† 3)
is
(† 8)
, unscrew it
EN 5