Safety Recommendations; Ec Declaration Of Conformity - SKF TKSU 10 Mode D'emploi

Safety recommendations

• Do not expose the equipment to rough handling
or heavy impacts.
• Always read and follow the operating
instructions.
• Opening the housing of the instrument may
result in hazardous mishandling and voids
warranty.
• The equipment should not be used in areas where
there is a risk for explosion.
• Do not expose the equipment to high humidity
or direct contact with water.
• All repair work should be performed by an
SKF repair shop.
• Using any other headset than the one supplied
with the instrument can cause internal damage
to the detector.

EC Declaration of conformity

We, SKF Maintenance Products, Meidoornkade 14,
3992 AE Houten, The Netherlands herewith declare
under our sole responsibility that the products
described in these instructions for use, are in
accordance with the conditions of the following
Directive(s):
EMC DIRECTIVE 2014/30/EU
EUROPEAN LOW VOLTAGE DIRECTIVE 2014/35/EU
RoHS DIRECTIVE (EU) 2015/863
and are in conformity with the following standards:
EN 61010-1:2010
Safety requirements for electrical equipment
for measurement, control, and laboratory use –
Part 1: General requirements.
EN 61000-4-2:1995
Electromagnetic compatibility (EMC) –
Part 4-2: Electrostatic discharge immunity test.
EN 61000-4-3:2002
Electromagnetic compatibility (EMC) –
Part 4-3: Radiated, radio frequency,
electromagnetic field immunity test.
EN 61326-1:2013
Electrical equipment for measurement, control
and laboratory use, EMC requirements -
Part 1: General requirements.
Houten, The Netherlands, May 2020
Mrs. Andrea Gondová
Manager Quality and Compliance
EN 3