Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ELECTRICAL INSTALLATION
•
All heaters and controls must be grounded per NEC to pre-
vent electrical shock in case of unit failure.
•
Use only copper wire of the size and type indicated on the
heater.
•
Connect the heater using standard wiring NEC approved for
fi xed installation.
•
Use only copper wire of the size and type according to the
information on the heater and NEC.
Sauna heater installation
It is easiest to prepare for installation with the heater lying down.
To install the heater:
Lay the heater down front upwards.
Remove the screws and open the cover (see Figure 4, Page 3).
Connect the electrical cable (1) to terminal block.
WARNING! Always check that the heater is con-
nected to the correct main/phase voltage.
Electrical installation must be made by a licensed electrician in ac-
cordance with the National Electrical Code and local regulations.
Open the access cover from under the heater. Route the feed
wires through the holes provided in the bottom of the heater and
connect the wires to the terminal block. To determine the correct
wire size, see chart below. Use copper supply wire only, suitable
for minimum 90 degrees C. The heater must be grounded!
Connection/Wiring
Heater Wiring Size Chart
208 V 1 Phase
Output
Model
Amps
kW
SSU 5
3.5
17
SSU 5
4.6
SSU 7
5,3
26
SSU 7
7.0
-
SSU 8
6.3
30
SSU 8
8.3
-
Terminal Block Connections
1
240 V 1 Phase
Wire Size
Wire Size
Amps
AWG
AWG
12
20
10
10
-
-
-
30
8
8
-
-
-
35
8
1
2
3
4
5
G
2
Figure 4: Opening/closing the cover
Figure 5: Terminal Block
1. Electrical cable
2. Terminal for connection of electrical cable
Close the cover and tighten the screws (see Figure 4, Page 3).
5,3-8,3 kW
208/240 V~
3
4
1
2
L1
x3
208/240 V~
1
2
5
G
GND
L2
3
Publicité
Chapitres
Table des Matières
Dépannage
