HWAM 3110 Guide D'installation page 10

a I
SSEMbLy NSTRucTIONS FOR cOMbuSTION aIR SySTEM
Bottom/rear connection, HWAM 3110 on a pedestal
1. Remove the top plate (1).
2. Loosen and remove the bolt (2) that holds the two sides together. Loosen the bolt (3) that holds the
left side in position slightly, but do not remove it. Lift the left side (4) about 10 mm and pull it away
from the stove so that it is lifted free of the guide pins in the bottom plate of the stove. Repeat with
the right side (5).
3. Loosen and remove the 4 Allen bolts (6) behind the heat shield (7). Lift the heat screen slightly and
pull it away from the stove.
4. To remove any dirt or grease, wipe the edge of the heat shield (9+10) off with ethanol. Attach the
accompanying gasket (8) to the edge of the heat screen (9+10).
5. Secure the cover plate (11) to the inside of the heat shield with 3 self-tapping screws M4x10 mm (12).
6. Remove the rectangular pre-cut plate (13) at the bottom of the rear of the stove by tapping on it
with a soft hammer.
7. Lift the pedestal rear plate (20) off.
8. Remove the pre-cut plate (14) in the bottom plate of the stove by tapping on it with a soft hammer.
9. Secure the connector bush (15) to the bottom plate of the stove in the place where you removed the
pre-cut plate (14). Use the 3 accompanying self-tapping screws M4,2x9,5 mm (16). Insert and fasten
the screw from the bottom of the stove.
10. Make sure that the adjustment lever is set to minimum (anticlockwise). Otherwise, the heat shield
cannot be installed. Place the bottom of the heat shield between the stove and the guide pins (19) at
the back of the bottom plate on the stove and press it in towards the stove. Secure the heat shield
with the 4 Allen bolts (6).
11. Place the right side (5) on the guide pins on the bottom plate of the stove and press it in towards the
stove. Lift the side and press it lightly inwards until it engages behind the bolt (3) at the top. Secure
the bolt (3). Repeat with the left side. Finally secure the bolt (2) that holds the two sides together.
12. Replace the top plate (1) on top of the stove.
13. Pull the insulation sleeve (18) onto the flexi-hose (17) and mount the flexi-hose on the connector
bush (15).If needed, the insulation sleeve can be attached with a cable fastener.
14. If the fresh air supply is connected through the rear, remove the pre-cut plate (21) at the rear of the
pedestal by tapping on it with a soft hammer. Connect the fresh air supply and place the rear plate
(20) on the pedestal.
15. If the fresh air supply is connected through the bottom, make sure the stove is placed in its proper
position and connect the fresh air supply. Then place the pedestal rear plate (20) on the pedestal.
16. Use the accompanying rubber plugs (22) to close the holes (23) in the bottom plate of the wood-
burning stove and seal off the fresh air system.
10
E
NgLISh