FS IMC-1F1T Guide De Démarrage Rapide page 14

5. Troubleshooting
This chapter contains information to help you solve issues. If the IMC-1F1T is not
functioning properly, make sure it is set up according to instructions in this Quick
Start Guide.
The per port LED is not lit
Solution: Check the cable connection of the IMC-1F1T.
Performance is bad
Solution: Check the speed duplex mode of the partner device. The IMC-1F1T
usually runs in auto-negotiation mode. If the partner is set to half duplex, the
performance will be poor.
Per port LED is lit, but the tra c is irregular
Solution: Check that the attached device is not set to dedicate full duplex. Some
devices use a physical or software switch to change duplex modes. Auto-negoti-
ation may not recognize this type of full duplex setting.
The IMC-1F1T doesn't connect to the network
Solution: Check per port LED on the IMC-1F1T. Make sure the cable is installed
properly. Make sure the cable is the right type. Turn o the power. After a while,
turn on the power again.
- 13 -
EN