Metabo HPT DH 36DPA Instructions De Sécurité Et Mode D'emploi page 25

Center
Code No.
pin
– –
(A) 982684
(B) 982685
4. Demolishing operation (Hammering only)
○ Bull point (Round type) (SDS-plus shank)
Code No. 303046
○ Bull point (Square type) (SDS-plus shank)
Code No. 316656
5. Groove digging and edging (Hammering only)
○ Cold chisel (SDS-plus shank)
Code No. 316657
○ Cutter (SDS-plus shank)
Code No. 316658
6. Grooving (Hammering only)
Grooving chisel (SDS-plus shank)
Code No. 316659
7. Bolt placing operation with Chemical Anchor.
(Rotation + Hammering)
Standard socket (SDS-plus shank)
on the market ○ 1/2" (12.7 mm)
○ 3/4" (19 mm)
Core bit (outer diameter)
1"(25 mm)
1-1/8" (29 mm)
(A) 1-1/4" (32 mm)
1-3/8" (35 mm)
1-1/2" (38 mm)
1-3/4" (45 mm)
(B)
2" (50 mm)
Chemical Anchor Adapter
(Code No.303044)
Chemical Anchor Adapter
(Code No. 303045)
Code No. Core bit shank
982672 Overall length
982673
982674 (A)
982675
982676
982677
(B)
982678
8. Drilling holes and driving screws (Rotation only)
○ Drill chuck, chuck adaptor and chuck wrench
Special screw
Code No. 981122
Chuck adaptor G
(SDS-plus shank)
Code No. 303623
9. Dust cup, Dust collector (B)
Dust cup
Code No. 971787
10. Rotary hammer grease
1.1 lbs (500 g) (in a plastic case) Code No. 335781
0.13 lbs (60 g) (in a tube) Code No. 335782
NOTE
Specifi cations are subject to change without any obligation
on the part of the metabo HPT.
English
Code No.
303625
4-1/8"
(105 mm)
12"
303626
(300 mm)
12"
303627
(300 mm)
Drill chuck (13VLRB–D)
(includes chuck wrench)
Code No. 321814
Chuck wrench
Dust collector (B)
Code No. 306885
25