Before Use; Prior To Operation - Metabo HPT DH 36DPA Instructions De Sécurité Et Mode D'emploi

(2) Turn the USB power switch ON (Fig. 9)
When you turn the USB power switch ON, the USB
power indicator lamp will light up.
Rubber cover
USB cable
USB port
(3) Connect the USB cable. (Fig. 9)
Pull back the rubber cover and fi rmly plug in a
commercially available USB cable (appropriate to the
device being charged) into the USB port.
○ When the power cord is not plugged into an outlet and
the battery runs out of power, power output will stop
and the USB power indicator lamp will shut off .
○ When the USB power indicator lamp goes out, change
the battery or plug the power cord into an electrical
outlet.
(4) When charging is completed
○ The USB power indicator lamp will not go out when a
USB device has been completely charged.
To verify charge status, check the USB device.
○ Turn the USB power switch OFF and unplug the power
cord from the electrical outlet. (Fig. 9)
○ Remove the battery from the charger and place the
rubber cover over the USB port.

BEFORE USE

Check the work area to make sure that it is clear of debris
and clutter.
Clear the area of unnecessary personnel. Ensure that
lighting and ventilation is adequate.

PRIOR TO OPERATION

1. Confi rming condition of the environment
Confi rm that the work site is placed under appropriate
conditions conforming to prescribed precautions.
2. Attaching the side handle (Fig. 10)
(1) Turn the grip of the side handle to loosen it and push it
in until it comes in contact with the housing.
USB power
switch
USB power
indicator lamp
Fig. 9
(2) Adjust the side handle to the angle that allows the
easiest use, then turn the side handle's grip fi rmly to
lock it place.
Loosen
3. Mounting the drill bit (Fig. 11, 12)
CAUTION
To prevent accidents, make sure to turn the
switch off .
NOTE
When using tools such as drill bits, etc., make sure to
use the genuine parts designated by our company.
(1) Clean, then smear the shank portion of the drill bit with
the grease or machine oil.
(2) Insert the drill bit in a twisting manner into the tool
holder until it latches itself. (Fig. 11)
The grip need not be adjusted during bit installation.
Grease
Drill bit
Drill bit
Part of SDS-plus shank
(3) Check the latching by pulling on the drill bit.
English
Tighten
Fig. 10
Front cap
Grip
Fig. 11
13