General Instructions; Useful Tips; Use; Cleaning - Imetec M1501 Mode D'emploi

DESCRIPTION Of THE APPLIANCE AND ITS ACCESSORIES
Refer to page I of the Illustrative Guide to check the contents of the package.
All the figures are on the inside pages of the cover.
1. Heating plates
2. On/off switch I/O
3. Plate closing lock (if present)
4. Temperature adjustment wheel (if present)
5. Operation LED (if present)
For the appliance features, refer to the external packaging. Use the supplied accessories only.
A quick understanding of how to use the hair straightener will allow you to establish the exact
application time to achieve the desired effect on your hair.
• Ensure your hair is dry, clean and without any trace of hairspray, hair mousse or gel.
• Comb your hair ensuring there are no knots. Start straightening from the nape of the neck,
proceed on the sides and finish on the forehead.
• During use, when the plates heat and cool, position the appliance on a smooth and heat
resistant surface.
• While straightening, be careful not to near the plates too much to the sensitive parts of the
face, ears, neck or head.
• Leave the plates to cool down completely when finished, before putting the appliance away.
PREPARING YOUR HAIR
• Wash hair as normal and comb to remove knots.
• Dry your hair and brush from the roots to the ends.
INSTRUCTIONS fOR USE
• Connect the power cord (6) to the mains.
• Place the switch (2) in the ON position I.
• The hair straightener setting, where present, varies according to the model purchased (see
Hair Straightener Setting).
• Take a thin lock of hair, the same width as the plate and place it between the two plates.
• Keep the lock of hair taut with one hand and, with the other hand slide, the closed plate from
the roots down to the ends.
• Once you have finished styling your hair, turn the appliance off. Place the button (2) in the
OFF position O and unplug the hair straightener from the power socket.
HAIR STRAIGHTENER SETTING M1502
• The operation LED (5) will light up.
• Rotate the temperature adjustment wheel (4) to set the desired temperature between 150°C
and 210°C, depending on the type of hair and the desired effect; the temperature can be
adjusted at any time by rotating the wheel (4) clockwise (to increase the temperature) or anti-
clockwise (to decrease the temperature).
• The operation LED (5) flashes until the plates reach the set temperature.
• Once the temperature is reached, the operation LED (5) remains on.
HAIR STRAIGHTENER SETTING M1503-M1504
• The display (8) lights up.
• Select the desired temperature between 150°C and 230°C, depending on the type of hair
and the desired effect; the temperature can be adjusted at any time by pressing + or - (9).
• After having selected the desired temperature, the button lock can be activated by pressing the
+ button (9) for a few seconds. This function prevents accidental temperature changes while
using the straightener. The activation of the button lock is signalled by the operation LED
going on; The lock can be deactivated by pressing the + button (9) again for a few seconds.
• The display (8) flashes until the plates reach the set temperature.
• Once the temperature is reached, the display (8) remains on.
NOTE: steam may appear while straightening; this is excess humidity in the hair
that evaporates.
• Place the switch (2) in the OFF position O and unplug the hair straightener from the power socket.
• Wait for the heating plates (1) to cool down.
• Clean the surface of the heating plates (1) and the handle with a soft, damp cloth.
ATTENTION! Make sure all cleaned parts are completely dry before reusing the appliance!

GENERAL INSTRUCTIONS

USEfUL TIPS

USE

CLEANING

6
6. Power cord

7. Technical data

8. Display (if present)
9. Temperature adjustment buttons (+ button
and – button) (if present)