Impervious Sheath For Rj 45 Cable; Antenna - DELTA DORE Tycam 1100 Guide D'installation

6.7 Impervious sheath for RJ 45 cable

If necessary, you can fit the sealing accessory for the
RJ 45 cable.
① ②
1. Pass the network cable (7) (without plug) through the clamping nut (6),
the rubber seal (5) (inner edge of the rubber seal must be opposite the seal
plug), then through the seal plug (4), in this order.
2. Crimp an RJ-45 network plug (3) onto the end of the cable, taking care to
insert the twisted pairs of wires in the right order.
3. Place the seal (2) on the tip of the camera
network interface socket (1).
4. Insert the network plug (3) into the camera
network interface socket (1).
5. Insert the rubber seal (5) into the seal plug (4),
then screw the clamping nut (6) onto the seal
plug (4) without tightening it completely.
6. Align the seal plug snap-fit system (4) with the
notch on the camera network interface socket
(1), then screw the seal plug (4) a quarter turn
on the camera network interface socket (1).
7. Tighten nut 6, the sealed
connection of the RJ45 plug is complete.

6.8 Antenna

If you are using the Wi-Fi mode to connect the
camera to your local network (see § 4),
screw the antenna manually onto the camera.
If you are using another connection mode,
fit the antenna socket plug
to ensure the antenna socket is sealed.
26
③ ④
⑤ ⑥ ⑦
1- Camera network
interface socket
2- Seal
3- Network plug
4- Seal plug
5- Rubber seal
6- Clamping nut
7- Network cable from
the wireless router
① ② ③
①
②
④
⑤
⑥
⑥