Loewe 68482 Série Instructions D'installation page 16

11
12
13
16
Reference TV Floor Panel
TV set on the TV support
Wear the gloves for installing the TV set to avoid leaving fi nger
marks on the front of the TV set.
Place the Reference TV Floor Panel at the later installation site if
possible.
It is very diffi cult to move once the TV set has been installed.
The Floor Panel and TV set weigh about 90 kg.
Get a second person to help you lift the TV out of the packing.
Position the TV set on the TV support as shown (fi g. 11) and
hand on the TV set.
Connect the free end of the control cable with the connection
socket on the TV set, fi g. 13, arrow.
There are two holes in the TV support, fi g. 12.
Turn the two screws into the rear panel of the TV set through
these holes.
This protects the TV set against accidentally coming unhooked
and falling off.
The connecting cables (e.g. Power and antenna cables) are
connected to your device according to the respective operating
instructions
Fix the connecting cables using the cable tape as shown in fi g.
13. Make sure you leave an adequate length of cable for rota-
ting.
You can also make a loose connection with the second Velcro
tape or keep it in reserve.