Safety Instructions - Sinmag Europe SpiraloXL Mode D'emploi

out of the machine. Repeat as above until the trolley can be pushed in and pulled out
easily. And then tighten the adjusting screws of the bowl position guide rod. At last,
try to pull out the trolley and push it in again to make sure the trolley can go in and out
smoothly.

7. SAFETY INSTRUCTIONS

The machine is only used to knead dough. Don't overload the mixer.
1.
The maximum load of dough is 200 Kg. (for less than 125 Kg flour)
Please read this operation manual carefully before operation or
2.
maintenance. The nameplate should be taken attention as well.
All the safety cover and side boards should be closed during operation
3.
unless during maintenance.
Put the stop switch and emergency switch in the right position before the machine start-
4.
up.
Check whether the trolley has been located well before the machine start-up. If not, the
5.
indication lamp will be on. If the lamp is off, please turn the bowl and move the bowl
ahead slightly to make the bowl and friction-gear match well.
Check whether the power cables are not pressed or enlaced.
6.
Check whether the machine will stop when opening the safety guard.
7.
All the operators should comply with safety rules on clothing and wearing.
8.
Don't approach the machine when the machine is running unless you are the operator.
9.
Operator himself should not lean on the machine.
You must call a professional technician when there is electric trouble.
10.
Turn power off before maintenance.
11.
The machine must be in ground protection.
12.
Forbid girding metal during electric maintenance, and warn others against touching the
13.
button.
Turn off the power after daily use.
14.
Press every key only with finger, don't use any other tools
15.
ENG
21