Technical Data; Sound And Vibration; Before Starting The Equipment - EINHELL BT-MG 10,8 Li Mode D'emploi D'origine

Anleitung_BT_MG_10_8_Li_SPK1:_

5. Technical data

Motor power supply:
20000 min -
Idling speed:
Sanding/grinding area: 80 x 80 x 80 mm
Protection class:
Charge voltage for rechargeable battery:
Charge current for rechargeable battery:
Battery charger supply voltage: 230 V ~ 50Hz
Charging time: max. 3-5 hours
Battery type: Lithium-ion
Weight:

Sound and vibration

Sound and vibration values were measured in
accordance with EN 60745.
L pA sound pressure level
K pA uncertainty
L WA sound power level
K WA uncertainty
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three directions)
determined in accordance with EN 60745.
Handle
Vibration emission value a h = 3.26 m/s²
Uncertainty K = 1.5 m/s 2
Additional information for electric power tools
Warning!
The specified vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equipment
is used and may exceed the specified value in
exceptional circumstances.
The specified vibration value can be used to compare
the equipment with another electric power tools.
The specified vibration value can be used for initial
assessment of a harmful effect.
14.03.2011 13:19 Uhr
Reduce noise generation and vibration to a
minimum!
Use only equipment that is in perfect condition.
10.8 V DC
Maintain and clean the equipment regularly.
1
Adopt your way of working to the equipment.
Do not overload the equipment.
Have the equipment checked if necessary.
II /
Switch off the equipment when not in use.
10.8 V DC Wear gloves.
0.4 A
Residual risks
Even if you use this electric power tool in
accordance to instructions, certain residual risks
cannot be eliminated. The following hazards may
arise in connection with the equipment's
0.65 kg
construction and layout:
1. Lung damage if no suitable protective dust mask
is applied.
2. Damage to hearing if no suitable ear protection is
applied.
3. Health damage caused by hand-arm vibrations if
the equipment is used over a longer period or is
not properly guided and maintained.
76 dB(A)
3 dB

6. Before starting the equipment

87 dB(A)
3 dB Before you connect the equipment to the power
supply make sure that the data on the rating plate
are identical to the supply voltage.
6.1 Fitting the plug-in tools (Figures 1/2/3)
To fit the plug-in tools safely you should hold the
multifunction tool so that the ON/OFF switch (1)
points down and the tool mounting (2) faces up.
Place the plug-in tool (e.g. the triangular
sanding/grinding plant) on the tool mounting (2)
so that the pins of the tool mounting (2) fit into the
recesses in the plug-in tool.
Secure the plug-in tool using the supplied screw
(b) and tighten the screw securely with the Allen
key (5).
Make sure that the washer (a) is used for the
screw (b) (see Figure 3). In this case the
corrugated face of the washer must be placed
against the plug-in tool.
Check that the plug-in tool is secure.
6.2 Triangular sanding/grinding plate
Fit the triangular sanding/grinding plate to use the
equipment as a delta sander/grinder.
Seite 13
GB
13