Zibro CARMEN Manuel D'installation page 66

9. After cleaning carefully replace the fan and the screws.
D.3.6 Cleaning the fume extraction fan
The fume extraction fan needs to be cleaned twice a year by a by Zibro authorized
technician. The fan will become very dirty because of ash and soot. If not regularly
inspected and cleaned by a by Zibro authorized installer chances are likely that lifetime
will be shorter, it will become unbalanced and will produce more noise.
1. Remove the side covers of the stove. See chapter D.3.4.
2. Remove the 4 screws in the plate covering the fume extraction fan motor. See pic-
ture 30.
3. Remove the 4 bolts which are holding the fume fan motor. See picture 31.
4. Remove the sealant using a sharp tool, for example with a screwdriver. See picture 32.
5. Pull the motor with the rotor out. Clean the motor seat with a brass brush. Clean the
connection from the fan to the flue gas outlet. See picture 33.
6. Clean motor and fan combination gently with a brass brush and a vacuum cleaner.
See picture 34.
7. After all cleaning is done, fit the fume gas fan again with LOCTITE 598 (or equal) to
make a airtight fit.
8. Replace the fan and motor and replace plate covering fume extraction fan.
4
66
Picture 20
Picture 23
Picture 26
Picture 29
Picture 21
Picture 24
Picture 27
Picture 22
Picture 25
Picture 28