Honeywell HL12CES Mode D'emploi page 12

USE AND OPERATION (CONTINUED)
FUNCTION BUTTONS (CONTINUED)
• Fan Mode
For air circulation without air conditioner cooling.
•
Heating Mode*
This unit uses Heat-Pump technology which reverses the air conditioning cooling cycle by
transferring heat from the outside into the room – this is more energy efficient than traditional
electric heaters that generate heat instead of transferring heat into the room. These properties
make this heater ideal for use in autumn or spring when outdoor temperatures are not severely
cold, or as supplemental heating in colder rooms of your home.
When heating mode is selected the indicator light will shine. In this mode, the desired
temperature can be set between 16°C - 32°C (60°F - 90°F).
Note: The hoses must vent outside the room when using heating mode.
IMPORTANT: The Heat pump draws moisture from the air which then condenses into the
internal water tank. The unit will pause operation when the tank is full and will restart when the
tank has been emptied. It is recommended to use the heating mode in a room with 50%
humidity or lower. Avoid operating moisture-producing products or appliances such as a
humidifier or a kettle when using the unit in heating mode. See the "Draining Water
Condensation in Heat Mode" section for more information on draining the water tank.
• Sleep Mode
When the Sleep Mode is activated in Air Conditioning mode, the set temperature will increase
by 1°F or 1°C after the first hour of cooling and will increase a further 1°F or 1°C after the
second hour of cooling. The unit will maintain this temperature for 5 hours. The set
temperature will then reduce by 1°F or 1°C on the seventh hour and reduce a further 1°F or
1°C on the tenth hour. Sleep mode will then deactivate automatically.
In Heating Mode*, the set temperature will reduce by 2°F or 2°C after the first hour of heating
and will reduce a further 2°F or 2°C after the second hour of heating. The unit maintains
heating at this temperature for 5 hours. Then, the set temperature will increase 2°F or 2°C
at the seventh hour and will increase a further 2°F or 2°C on the tenth hour. Sleep mode will
then deactivate automatically.
Note: The Sleep Mode can be deactivated during cooling or heating mode by pressing any
button at any time.
FAN SPEED CONTROL
3 settings: High, Medium and Low.
*Applicable for models with Heating feature only.
EN 9