Honeywell HL12CES Mode D'emploi page 11

USE AND OPERATION (CONTINUED)
FUNCTION BUTTONS (CONTINUED)
TIMER CONTROL
The Timer is adjustable between 1 - 24 hours.
AUTO TURN OFF:
While unit is running, press the TIMER button
flashing, press the
automatically.
AUTO TURN ON:
When unit is in a standby mode (plugged in with power light on), press the TIMER button
and the display will flash. While the display is flashing, press the
number of hours until you want the unit to turn ON automatically.
TEMPERATURE CONTROL
• Used for adjusting the timer and thermostat.
• The default display is setting temperature.
• In cooling mode, when + or - button is pressed, the set temperature is displayed and may be
adjusted. After 5 seconds the display will revert back to room temperature.
Note: By pressing both
Celsius(°C) and Fahrenheit(°F).
MODE CONTROL
4 settings: Air Conditioning, Dehumidifying, Fan and Heating*.
The corresponding indicator light will illuminate to indicate the current mode setting.
• Air Conditioning Mode
Adjust fan speed and air temperature to suit your desired comfort level.
Temperature setting range is 16°C - 32°C (60°F - 90°F).
•
Dehumidifying Mode
Fan speed is preset to LOW.
Note: If the unit will be used mainly as a dehumidifier, do not connect the hose. Continuous
drainage is then necessary (refer to Continuous Draining for Dehumidifier Mode).
IMPORTANT: The Dehumidifier mode is used to support moisture reduction but should not
be expected to dehumidify to the same degree as a standard dehumidifier-only appliance. The
built-in dehumidifier automatically adjusts dehumidification based on ambient room temperatures.
It is not possible to adjust to a desired humidity percentage. The front display only shows the
current AND desired temperatures. It does not show humidity levels.
or button to select the number of hours you want the unit to turn OFF
/ buttons at the same time, the display will toggle between
and the display will flash. While the display is
*Applicable for models with Heating feature only.
EN 8
or button to select the