Table des Matières
Publicité
Installation Procedure
7
Fine adjustment of the left-right tilt of the
plasma display.
If the plasma display is slightly tilted to the left or right
after it is installed on the wall, you can adjust this tilt by
attaching the adjustment metal fitting (at lone location
on the right and on the left).
Insert the tilt adjustment metal fitting in the notch on
the top surface of the PDP side metal fitting that is
tilted downward and attach it by rotating the screw.
1
Rotate the screw until the gap between the wall side
metal fitting and the tilt adjustment metal fitting
disappears. When the gap between the wall side
metal fitting and the tilt adjustment metal fitting has
disappeared, the screw becomes difficult to rotate
and begins to lift up the plasma display.
2
Rotate the screw to adjust the tilt.
Tilt adjustment
metal fitting
Note
The range that the tilt can be adjusted by the screw is about
5 mm (3/16 inch) of the external dimension of the plasma
display and the screw rotates about 3 times. Be careful not
to rotate the screw too much. If the screw is turned too
much, the metal fitting may be damaged.
12
En
8
With the lock bar in the lock position,
fixing the lock plate firmly in place with
push rivet and the anchor screw (M6 x
14 mm (9/16 inch)) (1 location: left and
right sides) removed in step 1 (1 location:
left and right sides).
1
2
Screw head
Tilt adjustment
metal fitting
If there are speakers installed on both sides
Fix it in place with the anchor screw (M6 x 14 mm
(9/16 inch)) removed in step 1 (*1).
If there is a speaker installed on the bottom and if
a PDP-436SX is installed
Fix it in place with the anchor screw (M6 x 14 mm
(9/16 inch)) removed in step 1 (*2).
Locked
Unlocked
position
position
Lock bar in the lock position.
Anchor screw (*2)
Anchor screw (*1)
Plasma display
Publicité
Table des Matières
