Table des Matières
Publicité
3
Removing the PDP side metal fitting.
1
Lift the lock bar to the position where the lock on the
PDP side metal fitting is released.
2
While holding the lock bar up, pull out the bottom of
the PDP side metal fitting.
3
Lift up and remove the PDP side metal fitting.
1
PDP side metal fitting
2
Wall side metal fitting
4
Attaching the PDP side metal fitting to the
plasma display.
1
Spread a sheet or similar material so that the display
will not be scratched or damaged.
2
Fix the PDP side metal fitting firmly to the plasma
display with bolts M8 (6 locations).
Bolts M8
PDP side
metal fitting
Note
Always install it on top of a stable table or similar
surface.
If you plan to install speakers and cables, please install
them at this stage.
Do not connect the cables to the other device.
For the speaker installation method, refer to the
speaker installation procedure in the operating
instructions for the plasma display.
3
Lock bar
1
Top side of the PDP
side metal fitting
Top side of the
plasma display
5
Installing the wall side metal fitting on the
wall.
Fix it firmly in place symmetrically to the left and right (4
or more locations).
The screws and bolts used for this step vary according
to the strength and the materials of the wall, so prepare
these separately.
Note
Perform this installation work after confirming the strength
of the wall, columns, etc.
6
Hanging the hook of the PDP side metal
fitting on the wall side metal fitting
1
Hang the hook on the ceiling surface part of the PDP
side metal fitting on the wall side metal fitting.
2
Raise the lock bar to attach the plasma display. Make
sure that the lock bar is fully lowered.
Hook of the PDP side
metal fitting
2
Lift the lock bar from its unlocked
position to the top edge.
Always have at least 2 people do this task.
Always make sure that the hook has been hung.
Caution
Note
If speakers are attached, do not hold the speakers to
perform this attachment.
Be careful that the wiring etc. is not caught in the
metal fitting or the plasma display. Be extremely
careful if there is a speaker attached, because if there
is, wiring etc. is easily caught between the wall and
the speaker.
Installation Procedure
1
Hang the hook.
11
En
Publicité
Table des Matières
