Ryobi GD125 Manuel D'utilisation page 55

PROBLEM
When programming a car remote,
a buzzer sounds and all console
buttons blink seven times.
During operation, the opener
struggles to raise or lower the
door and then stops. A buzzer
sounds continuously and the
SET ( ) button in the console
blinks continuously.
When a car remote, smartphone,
or keypad is used a buzzer sounds
and the UP and DOWN buttons
in the console blink continuously.
Garage door begins to close then
stops and reverses.
Garage door opener is in the
fully open position and cannot
be closed with a car remote,
smartphone, or keypad.
Garage door opener does not
activate when indoor keypad is
pressed.
Garage door opener activates, but
the garage door does not move.
TROUBLESHOOTING
POSSIBLE CAUSE
A step for programming the car
remote was not completed within
two minutes.
Motor amperage has exceeded
8 amps.
Door spring (torsion spring and/or
extension spring) is damaged.
Door is too heavy, broken, or
stuck.
The travel limits have been erased
or have not been set correctly.
The garage door opener hit an
object while it was closing.
The safety sensors are not
receiving power.
The wire connecting the keypad to
the power head has been damaged.
Circuit breaker is tripped.
The outer trolley is not engaged with
the inner trolley.
The door arms are not connected
to the outer trolley.
The door arms are not connected
to the garage door.
55 - English
SOLUTION
Complete each step for programming the
car remote within two minutes.
Unplug the unit. Have door spring or door
repaired or replaced by a qualified service
technician.
Unplug the unit. Have door spring repaired
or replaced by a qualified service technician.
Unplug the unit. Have door repaired or
replaced by a qualified service technician.
Set the travel limits as described in the
Installation section.
Remove the object and continue operation.
Inspect sensor wires for damage and
ensure they are installed correctly. Reset
travel limits.
Replace damaged or broken wires.
Reset circuit breaker.
Pull the emergency release rope and raise
the garage door until the outer trolley
engages the inner trolley
Secure the door arms to the outer trolley
using clevis and hitch pin
Secure the door arms to the garage door
using clevis and hitch pin