Ryobi GD125 Manuel D'utilisation page 31

 Twist the gray striped wires from both sensors together
and insert them into the right door sensor terminal marked
with G.
 Twist the white wires from both sensors together and
insert them into the left terminal marked with W.
 For alignment instructions, see Aligning the Safety
Sensors later in this section.
"W"
Wire Terminal
(Door Sensor)
INSTALLING THE INDOOR KEYPAD
See Figures 57 - 61.
 Locate the following items:
Indoor Keypad
Low Voltage Wire
Insulated Staples (approx. 14)
Entrapment Label
Screws (1 in., Phillips Hd.) [2]
Drywall Anchors (2)
WARNING:
Do not use garage door opener if keypads or remotes
do not start and stop the motor. An opener that cannot
be controlled with a keypad or remote is dangerous,
can result in death or serious personal injury, and must
be repaired.
INSTALLATION
Wires
(Striped)
Wires
(White)
"G"
WARNING:
Make sure the keypad is mounted high enough to prevent
unauthorized activation of the garage door opener. It
should be placed at least five feet above the floor so that
it is inaccessible to children. Unauthorized activation of
the opener can result in death or serious personal injury.
WARNING:
Do not start or stop the garage door opener if there is a
person or object in the path of the door, the door has not
been properly balanced, or if you cannot see the doorway.
Failure to follow these instructions can result in death or
serious personal injury.
WARNING:
To avoid the risk of death, electric shock, or serious
personal injury ensure that the garage door opener is
unplugged before wiring the keypad.
WARNING:
Connect the keypad using low voltage wires provided
only. Using other wires may cause signal interference or
malfunction and can result in electric shock or serious
Fig. 56
personal injury.
 Find desired location indoors and in sight of the garage
door.
NOTE: The keypad should be at least five feet above the
floor so it is inaccessible to children.
31 - English
Back
Cover
Tab
Fig. 57