Ryobi GD125 Manuel D'utilisation page 15

WARNING:
Always wear eye protection with side shields marked
to comply with ANSI Z87.1 when assembling and
performing maintenance on this product. Failure to do
so could result in objects being thrown into your eyes
resulting in possible serious injury.
NOTICE:
Many of the illustrations in this manual show only portions
of the garage door opener. This is intentional so that we
can clearly show points being made in the illustration.
Never operate the garage door opener without all parts
securely in place and in good operating condition.
WARNING:
Confirm that the inner trolley is in the orientation shown
in Figure 10. An incorrectly installed inner trolley could
result in the garage door opener operating in the opposite
direction from its intended movement and result in death
or serious personal injury from the moving garage door.
ASSEMBLING THE RAILS
See Figures 8 - 18.
 Locate the following items:
Front Brace
End Rail Assembly
Support Rail (3)
Sleeves (3)
Pulley Rod Assembly
Outer Trolley
 Remove tie wrap from end rail and pulleys.
 Insert rear pulley into end rail. Slide together until pulley
is snug against the rail.
 Pull the front pulley and belt through the end rail and into
a sleeve.
 Slide the outer trolley into the end rail.
 Pull the release lever down and move outer trolley toward
the inner trolley until they are engaged.
ASSEMBLY
Sleeve
Outer
Trolley
15 - English
End
Rail
Front
Pulley
Belt
Release
Lever
Inner
Outer
Trolley
Trolley
Rear
Pulley
Fig. 8
End
Rail
Fig. 9
End
Outer
Rail
Trolley
Fig. 10
Inner Trolley
Fig. 11