Ryobi GD200 Manuel D'utilisation page 43

USING THE INDOOR KEYPAD
See Figure 77.
WARNING:
Keep moving door in sight when using indoor keypad.
Contact with moving door can cause DEATH or serious
injury.
The indoor keypad has backlights that turn on when garage
door opener is connected to a power supply. When the
keypad is locked, the backlights will blink.
 Install and wire the indoor keypad as described earlier in
the Installation section.
 To raise or lower the garage door, press and release the
UP/DOWN button.
 To enter and exit vacation mode, press and release the
LOCK ( ) button. When the unit is in vacation mode, it
Up/Down
Button
Light
Button
Lock
Button
OPERATION
 To turn the LED lights on and off, press and release the
Activating and Deactivating DC Module Ports:
 To activate a DC module port, press the number on the
 To deactivate a DC module port, press the number on
Module
Port #7
Module
Port #3
Module
Port #4
43 - English
can only be controlled using the indoor keypad and smart
phone. The unit will not respond to car remotes or the
outdoor keypad.
NOTE: The LEDs in the indoor keypad will blink when the
unit is in vacation mode.
LIGHT ( ) button.
NOTE: When the LIGHT (
light will illuminate for three minutes.
indoor keypad corresponding with the desired port. For
example, to activate module port #2 press NUMBER 2
on your keypad.
NOTE: An active module port can be used to power DC
modules. Multiple ports can be activated at once.
the indoor keypad corresponding with the port.
Module
Receptacle
Port #1
AC
Module
Receptacle
Port #5
) button is pressed, the LED
Module
AC
Port #2
Module
Port #6
Fig. 77