Ryobi GD200 Manuel D'utilisation page 16

WARNING:
Always wear eye protection with side shields marked
to comply with ANSI Z87.1 when assembling and
performing maintenance on this product. Failure to do
so could result in objects being thrown into your eyes
resulting in possible serious injury.
NOTICE:
Many of the illustrations in this manual show only portions
of the garage door opener. This is intentional so that we
can clearly show points being made in the illustration.
Never operate the garage door opener without all parts
securely in place and in good operating condition.
ASSEMBLING THE RAILS
See Figures 8 - 18.
 Locate the following items:
Front Brace
End Rail
Intermediate Rail
Front Rail
Sleeves (2)
Outer Trolley
 Remove tie wrap from rail and pulley.
 Pull the front pulley and belt through the end rail and into
a sleeve.
 Slide the outer trolley into the end rail.
 Pull the release lever down and move outer trolley toward
the inner trolley until they are engaged.
Front
Pulley
Sleeve
ASSEMBLY
End
Rail
Belt
Fig. 8
End
Outer
Rail
Trolley
Fig. 9
 Insert the edge of the end rail into the sleeve. Slide
together until rail clicks in place. If you cannot get the rail
to fit by hand, try gently tapping it with a rubber mallet
until it is snug and clicks into place. Be careful not to
pinch or damage the belt.
 Repeat this process to attach the intermediate rail, second
sleeve, and then the front rail. When assembled correctly,
the rails should not separate easily when pulled.
 Pull the front pulley and belt through the first sleeve, the
intermediate rail, the second sleeve, and to the top of the
front rail.
 Turn the tension nut on the pulley rod counterclockwise
to loosen. Remove the tension nut and spring from the
pulley rod.
Outer
Trolley
Outer
Trolley
Sleeve
Intermediate
Rail
16 - English
Inner Trolley
Release
Lever
Inner
Trolley
Fig. 10
End
Rail
Fig. 11
Sleeve
Fig. 12