Ryobi GD200 Manuel D'utilisation page 41

NOTICE:
Do not open or close the garage door using the indoor
keypad or remotes until the travel limits have been
properly set. Doing so could cause severe damage to
the garage door or the garage door opener.
Before setting the travel limit:
 Pull the emergency release rope down and manually open
the garage door until the outer trolley engages the inner
trolley.
Once you begin setting the travel limits, you have two min-
utes to complete each step. If a step is not completed within
two minutes, travel limit information for the open and closed
position will be erased.
To set the travel limit for the open position:
 Open the console door.
 Press and hold the UP button for three seconds. After
you release the button, it will begin blinking and continue
blinking until the travel limit has been set.
 Press and hold the UP button to move the garage door
to the open position.
 For fine adjustments, press and release the UP or DOWN
buttons.
 Once the door is in the open position, press the SET
button to store the travel limit. Once the travel limit
is stored, the UP button will stop blinking and shine
continuously.
NOTE: If the safety sensors are obstructed during this
process, travel limit information for the open and closed
position will be erased.
OPERATION
Inner
Trolley
41 - English
Correct
(Fully Open Position)
Incorrect
(Fully Open Position)
Inner Outer
Trolley
Trolley
Outer
Trolley
Release
Lever
Fig. 73
Fig. 74