Ryobi GD200 Manuel D'utilisation page 32

 Twist the white wires from both sensors together and
insert them into the left terminal marked with W.
 For alignment instructions, see Aligning The Safety
Sensors in the Operations section.
"W"
Wire Terminal
(Door Sensor)
INSTALLING THE INDOOR KEYPAD
See Figures 56 - 60.
 Locate the following items:
Indoor Keypad
Low Voltage Wire
Insulated Staples
Entrapment Label
Screws (1 in., Phillips Hd.) [2]
Drywall Anchors (2)
WARNING:
Do not use garage door opener if keypads or remotes
do not start and stop the motor. An opener that cannot
be controlled with a keypad or remote is dangerous,
can result in death or serious personal injury, and must
be repaired.
INSTALLATION
Wires
(Striped)
Wires
(White)
"G"
Fig. 55
WARNING:
Make sure the keypad is mounted high enough to prevent
unauthorized activation of the garage door opener. It
should be placed at least five feet above the floor so that
it is inaccessible to children. Unauthorized activation of
the opener can result in death or serious personal injury.
WARNING:
Do not start or stop the garage door opener if there is a
person or object in the path of the door, the door has not
been properly balanced, or if you cannot see the doorway.
Failure to follow these instructions can result in death or
serious personal injury.
WARNING:
To avoid the risk of death, electric shock, or serious
personal injury ensure that the garage door opener is
unplugged and the battery pack is removed before wiring
the keypad.
WARNING:
Connect the keypad using low voltage wires only to
prevent the risk of electric shock or serious personal
injury.
 Find desired location indoors and in sight of the garage
door.
NOTE: The keypad should be at least five feet above the
floor so it is inaccessible to children.
32 - English
Back
Cover
Tab
Fig. 56