KIKKA BOO DAY & NIGHT Mode D'emploi page 6

3. While holding the strap to keeping the centre of playpen oor upright (3A), use your other hand to lift the short top rails (3B)
until locked into position. Repeat step 3 for both long top rails. The centre of travel cot oor must remain upright until all rails are
locked.
4. Once all sides are locked into position, extend all corners and press centre of oor down (A) followed by outside edges (B), until
travel cot oor is in the locked position.
5. Add mattress to playpen with soft side up.
6. Put the straps under mattress through button holes and fasten securely on button of unit. Do not use travel cot without
mattress.
7. (1)Lift the two nylon protective aps found on the two corners and pull the zips fully to their respective ends. Assemble the
mattress support this way. (2) Cover the small gaps in the travel cot' s two corners, joining them together with the velcro tabs.
Insert the tubes into their holders in the base of the support as shown in the drawing. 8. Fit the tubes together.
III. INSTALL THE CHANGER TABLE
1. Changer table of children from birth up to 12 months and 11kg of weight. Pay attention to the correct tting of the D tubes.
Hook on the D tube must be placed towards the inside of the changer table, as shown in the picture. Correct tting of tubes C and
D inside the holes of the changer table.
2. Inset the two C tubes inside the 2 holes. ATTENTION! Holes on the C tubes must be placed towards the outside.
3. Fit the 4 tubes pressing the buttons on the D tubes, locking them in the holes of the C tubes, until a "click" is heard.
4. Place the changer table near the travel cot' s edges, act in the same way on both sides. Fasten the velcro of the changer table on
the top rails.
5. Push down the changer table to t it completely.
IV. FOLDING THE PLAYPEN
1. Remove mattress from playpen.
2. Hold the strap, pull centre of oor upwards(a).
3. Slightly lift top rail while pressing the centre button to release. Once rails released, push down. The centre of the cot oor must
be pulled up for top rails to release, if you can't release the centre button freely, lift centre plastic handle bar higher. Do not force. If
unit will not fold,look for a partially latched top rail. Squeeze the latch button to release the rail. It is possible for only one side of
the rail to release, ensure the rail is released on both sides of the latch button.
4. Once all top rails are released, fold travel cot to standing position.
V. THE USAGE OF SECOND LAYER
1. Fit the tubes together.
2. Take o the mattress.
3. Place the mattress support inside the cot, ensuring that all the hooks are hooked over the top rails, and place the mattress inside
the support.
VI. STORING
1. With playpen in upright position, route top hook and loop strap through plastic loops on opposite side of mattress. 2. With soft
side of mattress facing the travel cot route the two lower hook and loop straps through remaining plastic loops on mattress.
3. Insert playpen into carry bag and handle exposed for easy transportation.
* Store in a cool and dry area, especially in the summer. Do not store the travel cot in the boot of a vehicle.
* Carefully wipe o any mud and dirt. To clean the body, wipe with a damp cloth. The main body might become moldy and musty
if not wiped dry.
* Excessive exposure to the sun could cause premature color fade.
* Mattress and bad are NOT machine washable. Clean with mild soap and a damp cloth.
ENGLISH