Continuous Mode; Timer Mode - Monacor International IMG STAGELINE FM-1510 Mode D'emploi

8.1.2 Continuous mode

In the continuous mode, the unit will emit fog continu-
ously.
1) To activate the continuous mode, press the red but-
ton CONT (18) so that it will engage and the red
LED (14) above the button will light up.
2) With the control VOLUME (16), adjust the fog out-
put quantity from 0 – 100 %.
3) To deactivate the continuous mode, disengage the
red button.
The continuous mode will take priority over the timer
mode, i. e. when the red button is pressed, the unit is
set to continuous mode even if the timer mode is acti-
vated with the button TIMER (15).

8.1.3 Timer mode

In the timer mode, the fog machine will automatically
emit fog in adjustable intervals of 5 to 140 seconds.
The fog times are just as long as the pauses.
1) To activate the timer mode, press the yellow button
TIMER (15) so that it will engage and the yellow
LED (13) above the button will light up.
2) With the control INTERVAL (12), adjust the intervals
between the individual fog outputs.
3) With the control VOLUME (16), adjust the fog out-
put quantity from 0 – 100 %.
4) To deactivate the timer mode, disengage the yellow
button; the LED above it will be extinguished.
8.2 DMX mode
After completing the heating process (approx. 4 min-
utes after switching on), the fog machine is ready to
emit fog.
Hint: To visually indicate that the unit is ready to
emit fog, the remote control provided can be
connected to the jack REMOTE CONTROL
ONLY (8): once the heating process is com-
pleted, the green LED (17) will light up.
1) Switch on the DMX controller.
2) On the DMX controller, adjust the desired DMX
value for the channel used for activating the fog
machine.
Value Function
0 – 7 no fog output
8 minimum fog output
↓ ↓
255 maximum fog output
Note: In the DMX mode, the fog machine cannot be
controlled via the remote control.
All rights reserved by MONACOR
be reproduced in any form or by any means for any commercial use.
®
INTERNATIONAL GmbH & Co. KG. No part of this instruction manual may
9 Cleaning
For cleaning the outside of the unit, only use a dry, soft
cloth; never use chemicals or water which may get
inside the unit.
Due to the viscosity of the fog fluid and the high
vaporizing temperature, fog machines are susceptible
to clogging. After approx. 40 hours of operation, it is
therefore recommended to clean the unit with a fluid
consisting of 80 % distilled water and 20 % vinegar.
1) Disconnect the fog machine from the mains and
allow it to cool down sufficiently.
2) Completely empty the tank.
3) Fill the tank with the cleaning fluid.
4) Operate the unit with the cleaning fluid in a suffi-
ciently ventilated environment until the tank is
empty.
5) Refill the unit with fog fluid and create fog for
approx. 3 minutes to remove any acid residues from
the unit.
10 Specifications
Heating power: . . . . . . . . . . . 1250 W
Heat-up time: . . . . . . . . . . . . approx. 4 minutes
Tank capacity: . . . . . . . . . . . 1.8 litres
Fog output: . . . . . . . . . . . . . . approx. 566 m
Power supply: . . . . . . . . . . . 230 V~/50 Hz
Power consumption: . . . . . . 1300 VA
Dimensions (W × H × D): . . . 245 × 310 × 430 mm
Weight: . . . . . . . . . . . . . . . . . 6.2 kg
Subject to technical modification.
3
per minute
GB
11